Filter
Top Products
MULTITASKER
400-0367-005 23
7.3 SUMMARY OF COMMANDS
Basic Commands
1) [VER] Display software version
2) [C] Display card status (short)
3) [CnS] Save all card settings
4) […S] Save one command setting
5) [SIO] Display card status (long)
6) [CLR] Reset card to defaults
7) [TEST] Test internal memory ICs
8) [HELP] Display help file
Feedback Control
9) [FBD] Feedback delay on/off
10) [?] Display system information
11) [?C] Display card information
12) [AFB] Enable/disable feedback
13) [ACK] Display acknowledge, [ ]
14) [STA1] Enable auto-feedback
15) [STA0] Disable auto-feedback
16) [...F] Display OK after command
Matrix Setup
17) [MAT] Set matrix configuration
18) [MjCn] Select matrix configuration
19) [MODE] Turn blocking on/off
Card Control
20) [ONmm] Turn on one output
21) [ON] Turn on all outputs
22) [OFFmm] Turn off one output
23) [OFF] Turn off all outputs
24) [ImmOxx] Connect one-in to one-out
25) [ImmO*] Switch one-in to all-out
26) [INmmS] Display outputs on input
27) [OUTmmS] Display input on output
28) […P] Preload path for [SW]
29) [SW] Switch preloaded path
30) [SEL] Set path for volume adjust
31) [+] Increment volume
32) [-] Decrement volume
33) [VOL] Set absolute volume
34) [SDI] Input signal detect
35) [SDO] Output signal detect
ID Commands
36) [RSI] Reset Card IDs to default
37) [SIDn] Set all Card IDs
38) [SIDnCi] Set one Card ID
39) [SID+] Set all Card IDs to an offset
40) [RSN] Display card slot number
Group Commands
41) [WR] Add card(s) to a group
42) [RMC] Remove card(s) from group
43) [RMG] Delete group
44) [RD] Display group members