Filter
Top Products
Operation – Operation Procedures
12 Smart-UPS® VT 10-40 kVA 400V, 208V, 200V – Operation 990-2282A-001
How to turn load OFF/ON via the display interface
Turn Load OFF – How to disconnect the UPS output to the load equipment.
Turn load ON – How to connect the UPS output to the load equipment.
Warning
Disconnecting the UPS output to the load does NOT de-energize the UPS! Always follow
the total power off procedure if you need to de-energize the UPS in emergency
situations, see section How to perform a total power off!
If the UPS is running in parallel operation
this procedure must be carried out on each
UPS.
If the UPS is running in parallel operation
this procedure must be carried out on each
UPS.
Chrg 100%
Load 000%
xxxVin 000Vout x0Hz
Runtime: 0hr 0m
Press
Control
Status
Setup
Logging
Display
Diags
Help
Use
Press
Turn Load Off
Press
Use
Confirm:
Turn Load OFF
NO, Abort
YES, Turn Load OFF
Use
Press
Chrg 100%
Load 000%
xxxVin 000Vout x0Hz
Runtime: 0hr 0m
Press
Control
Status
Setup
Logging
Display
Diags
Help
Use
Press
Turn Load On
Press
Use
Confirm:
Turn Load OFF
NO, Abort
YES, Turn Load ON
Use
Press