Filter
Top Products
36 - PowerBook G4 (12-inch) Take Apart
Hall Effect Sensor Board and Cable: PowerBook G4
Procedure
1. Remove the screw from the hall effect sensor board.
Warning: When replacing the board, make sure you use the same screw. A longer
screw could scratch the optical media.
2. Remove the tape, if provided, from the corner of the optical drive, and disconnect the
3-pin connector from CN4 at the DC-to-DC board.
3. Remove the board with cable from the computer assembly.
4. Install the replacement hall effect sensor board and cable, and reassemble and test
the computer.