Filter
Top Products
PowerBook G4 (1GHz/867MHz) Bulb Wire Cable - 2
Procedure
Important: With the bottom case removed, be careful if turning over the computer. Some
components could become loose and fall out.
Note: Remove any kapton tape as needed and replace during reassembly.
1. Loosen or remove the chrome T8 screw holding the heat exchanger alignment bracket
and the right side of the rib frame.
2. Disconnect the bulb wire cable connector.
Replacement Note: Make sure the alignment bracket secures the small alignment nub on
the end of the heat exchanger. Look from the side through the air vents of the top case to
verify that the ribs on the heat exchanger do not block the vents.
3. Pull up slightly on the rib frame then deroute the bulb wire cable.
Replacement Note: Route the replacement cable as shown. Use a black stick to tuck the
cable in over the backup battery cable between the speaker and top case.