Filter
Top Products
PowerBook G4 (1GHz/867MHz) AirPort Card- 7
4. Plug the antenna cable connector (Figure 11A) into the port on the AirPort Card,
located just below the plastic tab (Figure 11B). Make sure the connector is straight
before inserting it into the port.
Note: If tape was removed earlier, use it to secure the antenna cable to the card.
5. Push the AirPort Card down until the antenna cable connector is secured by the small
antenna clip (Figure 11C).
Important: Route the antenna cable (Figure 11D) between the edge of the computer
and the AirPort Card. Verify that the cable is away from the edge of the computer so
that it will not be pinched during reassembly and that it does not sag down into the
PC card slot area (below the AirPort Card). Take up any extra cable by tucking it in
where shown (Figure 11E).
6. Fold the plastic tab (Figure 11B) on the AirPort Card over the top of the card.
Note: The plastic tab must be folded over the card during the installation of the
bottom case; otherwise you will not be able to securely attach the bottom case to the
computer.
Figure 11
C
A
D
E
B