Filter
Top Products
Mounting Xserve RAID in a Rack 31
2 Join the shorter extender (C) and the flat piece (D) by placing the solid bar (E) between
them as shown in the illustration below.
a Fit the solid bar into the indentations in the two flat pieces.
b Place the cut-out area of the extender C and piece D over solid bar E.
c Use three shoulder bolts, washers, and nuts to fasten pieces C and D over solid bar E.
Use the pliers or wrench to hold the nuts as you tighten the bolts with the hex key wrench.
Note that even with the nuts tight you can slide the extender forward and backward.
3 Place the three holes of piece D over the three posts that extend from the wide side of
bracket A1 or A2.
4 Use three short screws to fasten piece C to bracket A1 or A2.
Tighten these screws all the way.
Pass three of the short
screws through the holes in part D and attach
them to part A1 or A2. Tighten them securely.
Make sure part D fits under the tab on part A1 or A2.
A1 or A2
D
C
E
Pass three of the shoulder bolts through the slot in part D, then through
the holes in part E, and finally, through the slot in part C.
Secure each bolt with a washer and
then a nut. Tighten them securely.