Filter
Top Products
32 Chapter 3
5 Fit the assembled pieces into the rack so that the extender’s lip is near the rear rail and the
lip of bracket A points toward the outer edge of the rack at the front rail.
The orientation of bracket A determines on which side of the rack it belongs. The lower part
of this L-shaped bracket faces inward (to support the system). The posts on the upper part of
the bracket face outward, and the extender is on the outside of the bracket. (In the
illustration, bracket A1 goes on the left as you face the rack; A2 goes on the right of the
system.)
6 Hold one of the A brackets against one rail on the front of the rack at the position you
marked, then place the metal template over the post on the front of the bracket.
7 Have the other person hold the second A bracket at the position marked on the other front
rail and place the metal template over the post on the front of the second bracket.
Adjust the mounting
bracket assemblies to fit the rack.
The flanges at both ends should
be on the outside of the rack posts.
Important The brackets must be attached to the rails at a 90-degree angle to ensure that
the Xserve RAID system is mounted securely. Use the template to guide you in attaching the
brackets correctly.