Filter
Top Products
Chapter 1. Introduction
5
Components
Front View
1. Port LEDs
The Port LEDs on the left are the On Line LEDs; the ones to the right are
the Selected Port LEDs:
The On Line LEDs light GREEN to indicate that the computer attached
to the corresponding port is up and running. If the LED is flashing, it
indicates that the Port is being used for cascading to another KH98
switch (see Two Stage Installation, page 10).
The Selected LEDs light ORANGE to indicate that the computer
attached to the corresponding port is the one that has the KVM focus.
The LED is steady under normal conditions, but flashes when its port
is accessed under Auto Scan Mode (see F7 SCAN, page 34).
2. Port Selection Switches
Press a switch to access the computer attached to the corresponding port.
Pressing Buttons 1 and 2 simultaneously for 3 seconds performs a
Keyboard and Mouse Reset.
Pressing 7 and 8 simultaneously starts Auto Scan Mode (see page 34).
3. Reset
Use a thin object (such as the end of a paper clip, or a ballpoint pen), to
press this recessed switch in to initiate a reset.
236
1
4 5
IPMI Enabled
9
KH98.book Page 5 Thursday, April 26, 2007 5:48 PM