Filter
Top Products
9
Chapter 2
Hardware Setup
Installation
Single Stage Installation
In a Single Stage installation, there are no additional KH98's cascaded down
from the first unit. To set up a single stage installation refer to the diagram
below (the numbers in the diagram correspond with the numbers of the
instruction steps), and do the following:
1. Plug your keyboard, mouse, and monitor into the unit's Console Ports.
2. Use KVM cable sets (as described in the Cables section on page 3), to
connect any available KH98 KVM Port to the Keyboard, Video and
Mouse ports of the computer you are installing.
3. Plug the Cat 5 cable that connects the KH98 to the IPMI Management
LAN. (This step is optional, see note below).
Note: This step is only applicable to IPMI installations. Only the first
KH98 unit should be connected to the IPMI Management LAN. See
picture below.
4. Plug the power cord that came with this package into the KH98's Power
Socket, and then into an AC power source.
5. Power on the monitor.
6. Power on the KH98.
1. Important safety information regarding the placement of this
device is provided on page iv. Please review it before
proceeding.
2. Make sure that power to all the devices you will be connecting
up have been turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function.
KH98.book Page 9 Thursday, April 26, 2007 5:48 PM