Filter
Top Products
Chapter 3. OSD Operation
33
F6 PET:
Clicking the F6 field, or pressing [F6], displays the Platform Event Trap alerts
received from any IPMI enabled server in your KH98 installation.
PET alerts are triggered whenever an a monitored event occurs on an IPMI
enabled server’s platform. These PET alerts contain information such as event
type (temperature threshold exceeded, power fault, etc.), BMC IP address, time
when it was triggered, sensor type, etc.
The KVM PET AUTO SWITCH
If the KH98 receives a PET alert while in idle mode (the screen is off), the
following will take place:
1. The screen will turn on (wake up).
2. The KH98 will switch to the PET alert sending server.
3. The PET alert information will be displayed on the screen.
To receive PET alerts, the SET KVM IP & MAC section under F4 ADMIN
should be previously configured by an Administrator. See SET KVM IP &
MAC, page 30.
Note: When a new PET alert is received, the F6 PET ALERTS field on the
OSD main screen will blink. Alternatively, the top left hand side of the
monitor screen will also blink when not logged in to the OSD.
Up to 32 PET alerts can be viewed on the OSD main screen. After the
maximum number is reached, the older messages will be deleted.
KH98.book Page 33 Thursday, April 26, 2007 5:48 PM