Filter
Top Products
12 AutoView 1000R/ AutoView 2000R Installer/User Guide
CAUTION: To reduce the risk of electric shock or damage to your equipment -
- Do not disable the power cord grounding plug. The grounding plug is an important
safety feature.
- Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.
- Disconnect the power from the appliance by unplugging the power cord from either the
electrical outlet or the appliance.
To install the AutoView 1000R/2000R hardware:
1. Connect a terminal or PC running terminal emulation software (such as
HyperTerminal
®
)to the confi guration port on the back panel of the
appliance using an RS-232 DB9 null modem cable. The terminal should
be set to 9600 baud, 8 bits, 1 stop bit, no parity and no fl ow control.
2. Plug the supplied power cord into the back of the appliance and then into
an appropriate power source.
3. When you turn on the power, the Power indicator on the front of the
appliance will blink for 30 seconds while performing a self-test.
Approximately 10 seconds after it stops blinking, press the Enter key to
access the main menu.
To confi gure the AutoView 1000R/2000R hardware:
1. You will see the Terminal Applications menu with six options. Select
option 1, Network Confi guration.
Figure 2.3: Network Configuration Menu