Filter
Top Products
THE BADGER
®
-RADIX
®
User Guide
February 2007
Page 15 of 73
Make a note of the large number you see in the center of the screen. CONNECT will ask
you about this number during the load function if you have more than one Badger-Radix
handheld.
In Badger CONNECT, choose the Load Collector page for the Badger Radix collector
type. Steps 1 and 2 (choosing the route to load and verifying that it is correct) remain the
same. When you are ready to load the route, click on the Load Route button (step 3).
Badger CONNECT will make the connection to the Loader-Charger(s). If you have one
Loader-Charger connected, the meters will be loaded. If you have two or three Loader-
Chargers, Badger CONNECT will display a list of “communications addresses”. Choose
the one that matches the number on the display and click OK. The meters will be sent to
the Badger-Radix.
Unloading the Badger-Radix is very similar. From the Route Transmit screen, press the
Send Route “S” key. You’ll see this screen.
If you do not wish to send the readings, press the “C” key. To send the readings back to
Badger CONNECT, press the “Enter” key. You will see a screen like this.