Filter
Top Products
THE BADGER
®
-RADIX
®
User Guide
February 2007
Page 61 of 73
Stopping a Transmitter
To use the Programmer to Stop the transmitter’s meter reading broadcast, align the
optical port and the LED and touch the Stop Radio button “T”. If the port and the LED
are aligned, you’ll hear a beep and see these messages that indicate success:
• Stop
• Done
Here’s what you would see if you stopped transmitter # 72110115.
Changing the Odometer setting
The most common use of the SET ODOMETER function is to clear a Tamper condition
reported by a Transmitter. Besides clearing the tamper, the SET ODOMETER function
will also allow you to change the meter reading stored in the transmitter.
Changing the odometer setting is performed in two steps:
• Perform a READ function
• Enter the new odometer value and perform the SET ODOMETER function
The READ function is described above. Once the Badger ORION
®
transmitter has been
successfully read, you can continue with the SET ODOMETER function.
To use the Programmer to clear the tamper (the transmitter’s meter reading matches the
odometer value), press the PROGRAM “P” key once the READ function has completed.
The Programmer will clear the tamper without changing the stored meter reading.
To use the Programmer to change the transmitter’s stored meter odometer value, enter the
odometer value you want the transmitter to store into the odometer field as follows. First,
use the delete key on the keyboard below the screen (upper left corner, first press the
Badger-Radix key) to remove the current reading from the field. Next, enter the desired
reading by pressing the number keys on the keyboard. Finally, align the optical port and
the LED and touch the Set Odometer button “O”. If the port and the LED are aligned,
you’ll hear two beeps and see these messages that indicate success: