Filter
Top Products
MatrixPRO-II DVI 16x16 Router
________________________________________________________________________
User’s Guide Rev. 01
20
▪ Press ENTER key button to complete the process.
▪ The default setting is 192.168.0.246
4.4.4 MAC Address
▪ MAC Address of the unit is displayed. This is a fixed value and cannot be changed.
4.4.5 UDP Port Number
▪ This will display the UDP port number.
▪ The default UDP port number is 03000. The UDP port number cannot be changed
using the front panel keys.
.
4.4.6 Video Generator
▪ The Video Generator (Reference Output) is set at 1280x1024@60Hz with a Vertical
Bar pattern. This output cannot be changed.
4.4.7 Monitoring Output
▪ It allocates input to Monitor Output port for monitoring uses.
▪ The cursor shows that it is selected and activated.
▪ Input 3 key button decreases the number.
▪ Input 4 key button increases the number.
=Monitoring Output=
Old Input: 01
New Input: 01
1) Connect a display to the Monitoring Output port and any video sources to the
DVI input ports on the real panel.
2) Select an input port by pressing input 3 or 4 key button.
3) Press ENTER key button to complete the process.
4.4.8 EDID Configure
▪ Sets the EDID information in input port.
▪ MATRIXPRO-II DVI 16x16 supports three types of EDID setting: Default Mode, Auto
Mix Mode and Output Copy Mode. For more information, refer to Chap. 5.2.
▪ The cursor shows that it is selected and activated.
▪ Input 1 and 2 key buttons select YES and NO.
▪ Input 3 and 4 key buttons move left and right (Change EDID mode).
▪ Input 5 and 6 key buttons move down and up (Decrease and increase the port
number).
Port number setting in this section is used for UDP with supplied PC program not TCP/IP
with web browser or Telnet. For TCP/IP, port number 23 is fixed value.