Filter
Top Products
MatrixPRO-II DVI 16x16 Router
________________________________________________________________________
User’s Guide Rev. 01
28
The left side of the control application shows the signal connection, resolution, EDID,
and routing status of the inputs and outputs.
5.3.1 Input / output connection
▪ Click on one of the input channels and click on any of the output channels. If
you click on input CH05 (Camera #1) and click on outputs CH05, CH06, CH07
and CH08, the input signal from CH05 will be connected to outputs 05, 06, 07
and 08 as shown in Fig 4-5.
▪ To connect one input to all outputs, click All Link button and click desired input.
Then all of the outputs will be connected to the selected input.
▪ To disconnect all outputs, click the Link Clear button.
5.3.2 Input channel status
▪ Green LEDs above the input channel numbers indicate that a signal has been
detected. In fig 4-5 above, CH05 and CH10 have detected signals.
▪ When a signal has been detected, the resolution will also be displayed beneath
the channel name (ex. CH05=1920x1080p).
▪ If no signal is detected the input will display ‘Signal OFF’.
▪ DEF., AUTO, OUT. and USER, indicate the current EDID mode assigned to that
input channel (Refer to Chap. 4.2)