Filter
Top Products
MatrixPRO-II DVI 16x16 Router
________________________________________________________________________
User’s Guide Rev. 01
37
3. Connect the Service Port located on the rear panel of the MATRIXPRO-II DVI 16x
16 to a RS-232 (Comm port) on a PC using the supplied download cable (RJ1
1 to D-Sub 9Pin cable).
4. Select ②, ‘Comm port’ to select communication port of PC for RS-232
communication with MATRIXPRO-II DVI 16x16.
5. To enable Comm port, Click ③ when it shown as ‘Serial Port Enable’.
6. Power-On the MATRIXPRO-II DVI 16x16.
7. The firmware upload should then begin and the status will be shown in the message
box as shown below.
①
①①
①
②
②②
②
③
③③
③