Filter
Top Products
MatrixPRO-II DVI 16x16 Router
________________________________________________________________________
User’s Guide Rev. 01
21
===EDID Configure===
Entry EDID
Configure? _1: Entry
1) Press input 1 key button to enter the EDID Configure Mode.
===EDID Configure===
Input: 01 Default
Default Mode?
1: Y 2: N 3: << 4: >> 5: ∨ 6: ∧
2) Select an input port by pressing input 5 or 6 key button.
3) Press input 3 or 4 key button to change EDID mode.
3-1) If you select Default Mode, default EDID will be restored for allocated
inputs.
===EDID Configure===
Input: 01 Default
Default Mode?
1: Y 2: N 3: << 4: >> 5: ∨ 6: ∧
Press input 1 key button then, the MATRIXPRO-II DVI 16x16 will recover
the Default EDID to allocated input as below.
===EDID Configure===
EDID Copying….
EDID Reading….
3-2) If you select Auto Mix Mode, mixed EDID of all attached displays will be
saved in allocated input.
3-3) If you select Output Copy Mode, MATRIXPRO-II DVI 16x16 reads EDID
from any target displays and copies it in allocated input.
New EDID can be created or existing EDID can be modified using the Edit Data Mode. This
feature is recommended for advanced users only.
▪ Improper EDID setting can compromise the stability of the system
▪
Not all computer graphics cards will be able to output a custom EDID resolution.
▪ Be sure that you fully understand this feature prior to use.
For further information, please contact folsomsupport@barco.com
The EDID configuration that is shown next to the input number on the LCD
display is the current EDID mode