Filter
Top Products
PFWX-51B/PFWU-51B 10/02/2014
11
2.General
obstruction.
Ventilation inlet
Ventilation outlet
2.6
Installation process overview
Quick setup
The following steps describe briefly how to setup your PFWX-51B/PFWU-51B projector in a table mount front projection. Note
that each step refers to a corresponding procedure, which is more detailed and illustrated.
1.
Install the batteries of the remote control. See page 12: Remote control unit (RCU).
2.
Place the projector on a solid table in front of the screen at the expected throw distance. Adjust the feet to ensure that
the projector is installed at right angles (horizontally and vertically) with the screen. See page 19: Alignment of a table
mounted projector and page 36: Adjusting the lens by horizontal and vertical lens shift.
3.
Connect the projector with the local power net. See page 18: Connecting the projector with the power net.
4.
Select and install an appropriate lens, which covers the throw ratio ( = screen size / projector screen distance).
See page 9: Positioning the projector.
5.
Switch ON the projector. See page 18: Connecting the projector with the power net.
6.
Connect your source to the appropriate input module. See page 23: Input and Communication.
7.
Zoom and shift the lens until the image is properly projected on the screen, Do this by using the “ZOOM” and “FOCUS”
ring on the lens. If necessary, level the projector from side to side by turning the adjustable feet in or out. See page 16:
Lens zoom. or adjust the Lens Shift manually. See page 36: Adjusting the lens by horizontal and vertical lens shift