Filter
Top Products
3. OVERVIEW USER’s CONTROLS
Factory address setting of the modules
The factory address setting of the m odules is as follows:
Module Individual Address
Common Address
Cine VERSUM 80 address <9> no common address
Cine VERSUM 50 address <9> no common address
Cine VERSUM Master address <1> common address <0>
Common address: is a fixed address, stored in the module. The module will execute the commands sent by
a Remote Control, programmed with the
common address <0>.
3.5.2 Battery Insertion in the Remote Control
Where to find the batteries
The batteries are not placed in the remote control to avoid rem ote control operation in its package, res ulting in a shorter battery life
time.
How to install the batteries
1. Push the cover tab (A) with the fingernail a little backwa rds and pull upwards the cover top (B). (image 3-6)
2. Slide the cover forwards to remove. (image 3-7)
3. Push the battery body towards the spring and lift it u p to remove. (image 3-8)
4. Insert two AA size batteries, making sure the polarities match the + and – marks inside the battery compartment (image 3-8).
5. Insert the lower tab of the bat
tery cover in the gap at the bottom of the remote control, and press the cover until it clicks in place
(image 3-8).
Image 3-6
Battery cov
er unlock
Image 3-7
Battery cover removal
Image 3-8
Battery removal
12 R5976490 CINE VERSUM SYSTEM 17012003