Filter
Top Products
9. Service Mode
How to display the lamp menu
1. Push the cursor key ↑ or ↓ to highlight Lamp. (menu 9-26)
2. Press ENTER to select.
The lamp menu will be displayed. (menu 9-27)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-26
LAMP
Constant Light output [OFF]
Using [RS port]
Mode [NORMAL]
Serial number : R101111
Article number : R9840xxx
Run time : 10 hours
Remaining run time : 490
hours
Number of strikes : 10
Z_AXIS : 100
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 9-27
How to switch the constant light output?
1. Push the cursor key ↑ or ↓ to highlight Constant Light Output.menu 9-27
2. Press ENTER to toggle between [OFF], [SLAVE] and [MASTER].
[OFF] fixed power, no power adaptation.
[SLAVE] follows the master projector to adjust the CLO. When stand alone and the light output should be adjusted,
put on slave.
[MAS-
TER]
master projector to control the CLO in a chain of projectors.
Linked port
1. Push the cursor key ↑ or ↓ to hi
ghlight Using.menu 9-27
2. Press ENTER to toggle between [RS port] or [Comm port].
[RS port] RS port is used to make a linked connection
[Comm port] Comm port is used to make a linked connection
Mode switching
1. Push the cursor key ↑ or ↓ to highlight Mode.menu 9-27
2. Press ENTER to toggle between [NORMAL] and [ECONOMIC].
normal normal light output
economic
reduced light output (+ less noise)
9.10 Dimming
What is possible
ThelampcanbedimmedinsmallstepsonlywhenthelampisusedinNormal mode. The dimming can be done between normal
mode and economic mode.
112
R5976801 SLM R9+ 20/10/2004