Filter
Top Products
5. Setup
7. Press ENTER
Always select the highest rate (115200) unless otherw ise specified.
5.9 Network settings
What can be done?
These settings are used to set the Ethernet Communication parameters.
The Ethernet connection can be used to upload/download projector software and/or to set up communication (TCP-packets) with
the projector.
Following parameters are available :
MAC Address MAC Address of the projector (This is a non-adjustable value programmed into the Ethernet
board).
IP Address (Current) IP Address of the projector (This is a non-adjustable value ).
Subnet Mask Subnet Mask (This is a non-adjustable value )
Gateway Gateway (This is a non-adjustable value )
DHCP
DHCP setting:
• Yes: The projector will dynamically obtain its IP address from the DHCP server.
• No: The IP address needs to be entered manually. Note that when selecting Fxed IP
the IP settings fields are enabled
IP Address
Fixed IP Address of the projector : this field can be edited when Fixed IP is selected
Subnet Mask Subnet Mask : this field can be edited when Fixed IP is selected
Gateway Gateway : this field can be edited when Fixed IP is selected
Hostname
Hostname : this field can be edited when DHCP is selected
How to set up the network settings ?
1. Press the MENU key to activate the
Menu bar.
2. Push the cursor key ← or → to highlight Installation in the menu bar.
3. Push the ↓ key to pull down the Installation menu.
4. Push the cursor key ↑ or ↓ to highlight N etwork settings and press ENTER to select.
Image 5-14
34 R59770079 BARCO ID H250/500 23/07/2007