Filter
Top Products
5. Setup
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Language
5. Press → to pull down the menu
6. Use ↓ or ↑ to select the desired language
Image 5-17
7. Press ENTER
The language is adapted and a bullet shows the active selection.
5.10.2 Automatic startup
What can be done ?
The automatic startup allows to bypass the standby state i.e. start up without going in standby state after switching on the projector.
This means that the automatic startup allows immediate restart of the projector after a power failure (breakdown), i.e. without passing
through the standby state, by recovering the previous settings (previous source,...).
This function can be disabled if undesired or inadequate for safety reasons, etc.
CAUTION: If the Automatic startup function is enabled one must b e aware of the fact that it involves safety
precautions
Make sure that the projector (or the operators!) will not be affected by altered environm ental conditions when
restarting at power resume.
Unless it is required, it is advised to leave this setting OFF.
In case of a power breakdown, this may in trod uce unwanted co nditions at power resume : projector starting
up with h igh lamp temperature conditions, bad PC sta
tus, ...
How to enable/disable the Automatic startup?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Autom atic startup
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable/disable the automatic startup
36
R59770079 BARCO ID H250/500 23/07/2007