Filter
Top Products
724-746-5500 | blackbox.com
Page 10
724-746-5500 | blackbox.com
802.3af and 802.3at PoE Gigabit Injectors
2.5 Safety Procedures: General Precautions
Please read the following precautions carefully before installing and connecting the system to a power source:
NOTE: Only qualified and trained service personnel (in accordance with IEC 60950 and AS/NZS 3260) should install, replace, or
service the equipment. Install the system in accordance with country or national codes, or to the U.S. National Electric
Code if you are in the United States.
1. The building facilities in which the product will be used requires a fuse or circuit breaker no larger than 15 A for 120 VAC
(U.S.A.) or 10 A, 230 VAC (international). The building facilities must protect the PoE Injector from overcurrent or short circuits.
2. Before connecting the PoE Injector to a power source (including power cord requirements), read the PoE Injector Hardware
Installation procedure in Chapter 3. This procedure, as with all procedures and instructions, can be found in the PoE Injector
User Manual. To download a copy of the manual, visit ftp.blackbox.com.
3. To prevent the PoE Injector from overheating, do not operate the product in an area that exceeds the maximum recommended
ambient temperature of 40° C. Allow at least 3 to 4 inches of clearance around all ventilation openings.
4. To support the PoE Injector weight, do not stack the chassis on any other equipment. Shelf mounted equipment requires a sta-
ble and durable surface. When installed, do not push or pull on the PoE Injector when the equipment is installed.
5. The PoE Injector consists of two rows of “Data” and “Data & Power” ports. The ports use RJ-45 data sockets. Do not connect
telephone cables into these ports. Only RJ-45 data cables may be connect to these sockets.
6. Do not work on the PoE Injector system or connect or disconnect the cables, during periods of lightning activity.
7. The AC or DC plus/socket combination must be accessible at all times, as it serves as the main disconnect device to the
product.
8. Before servicing the product, always disconnect the product from its AC and DC source.
9. Disposal of this product should abide by all appropriate national laws and regulations.