Filter
Top Products
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 11
Chapter 3: Hardware Installation
3. Hardware Installation
3.1 Power Cord Requirements
Power cords must meet the requirements for the country where you will use the PoE Injector.
U.S. and Canada
• The cord must have a minimum of 10-A rated current competence.
• The cord must be UL
®
or CSA approved.
• The minimum requirement for the flexible cord is:
- 18 AWG (10-A)
- Three-conductor (line, neutral, ground)
- Type SV (stranded vacuum rubber jacketed) or SJ (stranded junior rubber jacketed) or SVT (stranded vacuum rubber
jacketed thermoplastic) or SJT (stranded junior thermoplastic)
• The plus must be earth-grounded with a NEMA 5-15 (15A, 125V) or NEMA 6-15P (15A, 250V) configuration.
Europe
Switzerland
• The supply plug must comply with SEV/ASE 1011.
Denmark
• The supply plug must comply with section 108-2-D1, standard DK2-1a or DK2-5a.
United Kingdom
• The PoE Gigabit Injector is covered by General Approval (section 16.16.060, NS/G/12345/J100003, for indirect connection to a
public telecommunication system.
France and Peru
• IT equipment cannot power this device. In the case of an IT-powered device, the unit needs to be powered by 230V through an
isolation transformer with a ratio of 1:1 and the secondary connection (neutral) is properly grounded.
• The PoE Gigabit Injector must have access to a nearby power outlet. By disconnecting the power cord from the outlet, you will
eliminate power from the device.
• The flexible cord that connects to the PoE Gigabit Injector must have a configuration to connect with an EN60320/IEC320 inlet
connector.
• According to the EN60950/IEC 950 specifications, this device functions under SELV (Safety Extra Low Voltage) conditions. The
conditions are true if the equipment and the connected device functions under SELV conditions.