Filter
Top Products
724-746-5500 | blackbox.com
Page 38
724-746-5500 | blackbox.com
802.3af and 802.3at PoE Gigabit Injectors
Table B-1 (Continued). SNMP MIB.
OID Name Type Value Description
2.3.6.1.24852.2.2.14.0 poeSystemControlDCPower*** INTEGER Read-write Sets the value of available
power in watts to be sup-
plied by secondary (DC)
power source.
2.3.6.1.24852.2.2.15.0 poeSystemControlBothPower*** INTEGER Read-write Sets the value of the total
available power in watts
to be supplied by both
power sources.
2.3.6.1.24852.2.3.1.1.1~24 poePortIndex INTEGER Read-only A unique value for each
port.
2.3.6.1.24852.2.3.1.2.1~24 poePortPowerEnable INTEGER Disable (1) Setting this object at a
(1.2147483647) Enable (2) value enable (2) enables
the detection mechanism
for this port.
Setting this object at a
value disable (1) disables
the detecton mechanism
for this port.
2.3.6.1.24852.2.3.1.3.1~24 poePortControlMaxPower*** INTEGER Read-write This command specifies
the maximum power in
[watts] to the port.
2.3.6.1.4.1.24852.2.3.1.4.0 poePortCurrentStatus*** INTEGER undercurrent(1) Describes a current port
overCurrent(2) status related to the
both(3) power generation. The
ok(4) value undercurrent(1)
indicates that the port
current is below the mini-
mal value since the attri-
bute was last cleared.
The value overCurrent(2)
indicates that the port
current exceeds the maxi-
mum value since the attri-
bute was last cleared. The
value both(3) indicates
that both undercurrent
and overCurrent were
detected since the attri-
bute was last cleared. The
value ok(4) indicates nei-
ther an undercurrent or
an overcurrent condition
has been detected since
the attribute was last
cleared.