Filter
Top Products
ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
239
iface canned dialer failed: reason
The Router failed to establish a modem link at the destination, using the factory-configured (canned)
dialup commands; the reason for failure is displayed: NO CARRIER, BUSY, NO DIALTONE, NO
ANSWER. Priority: LOG_ERR.
iface can’t dial: exceeded today’s quota of xxx minutes
The dialup command includes an option to set time quotas to limit the expense during set time
periods, for the cost of long distance telephone lines. Wait until the next day to establish a modem
connection (when the daily quota is reinstated), or explore the option with your network administrator
for extending the quota limit. Priority: LOG_ERR.
iface can’t dial: DCD is high
An attempt to dial out found Data Carrier Detect (DCD) signal already on. DCD must be off to dial
out. Check the telephone line to determine if the remote end is off hook. Check the modem
initialization string with the config show command to verify that the &C1 command is included, and use
the dialup status command to monitor the status of DCD. Priority: LOG_ERR.
iface can’t read dialer script file_name.
The Router was unable to find the specified dialer script, file_name. Be sure the file_name specified in
the dialup command is not misspelled, and verify that the file is on the boot disk. Priority: LOG_ERR.
iface current speed(bps): num
A syntax error was detected while attempting to set the modem speed. This error will cause any dialer
script to terminate prematurely and leave the modem speed unchanged. Correct the syntax error in your
dialup script file and run the script again. Priority: LOG_ERR.
iface dialer script failed failure_message
The dialer script has failed. Since the script file was most likely validated during its setup, check to see
if any of the destination parameters have changed. Continue debugging the dialer script until it is again
validated for use. Priority: LOG_ERR.
iface Dialing for destination_addr
An informational message that appears when dialing is initiated for a remote connection. This message
can help you determine what type of traffic is causing the Router to dial. Priority: LOG_DEBUG.
iface dialup link appears to be up
The Router has dialed a phone number and has established a connection over the interface. Priority:
LOG_INFO.
iface dropping link, exceeded today’s quota of num minutes
The dialup command includes an option to set daily time quotas, to limit the expense for the cost of
long distance telephone lines. Wait until the next day to establish a modem connection, or explore the
option with your network administrator for extending the daily quota limit. Priority: LOG_WARNING.
iface hanging up, status returned: modem_result_code