Filter
Top Products
ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER REFERENCE MANUAL
249
SNMP: bad host address, host_addr
The Router was unable to resolve the host_addr given in the snmp set command. Verify that host_addr is
correct; the name server or host data base has host_addr; and re-enter the command line.
SNMP: maximum host addresses exceeded, cant add: host_addr
An attempt was made to add another host_addr when the maximum of eight addresses per community
are already in the Access Control List (ACL). Delete an unused host_addr.
SNMP: community_name not added, maximum community names exceeded
An attempt was made to add another community_name when the maximum of eight community
definitions are already in the Access Control List. Delete any unused communities to make room.
SNMP: host_addr host address not in ACL
An attempt to delete host_addr from the Access Control List (ACL) failed. Use the snmp status -c
community_name command to display contents of the ACL. Check for typos, verify that host_addr is valid,
and re-enter the command line.
SNMP: Access control list is empty
A command line was issued that initiated display of community information and the Access Control
List was found to be empty.
SNMP: No communities configured
A command line was issued that initiated display of SNMP communities, and it was found that no
communities were configured.
A.2.12 SYSTEM G
ROUP
SYSTEM: Make sure the floppy disk is write enabled
Verify that the boot disk is write-enabled and fully inserted in the Router’s disk drive. Re-enter the
command line.
SYSTEM: Mismatch - password unchanged
During the process of changing the existing password and after the prompt to re-enter the new
password, a mismatch was found between the two entries. Try again.
SYSTEM: Please use at least one non-numeric character
A valid Router password requires at least one non-numeric character. Try again.
SYSTEM: Please use a longer passwd
A valid Router password requires at least eight characters. Try again.
SYSTEM: Cannot create config temp file: file_name
The Router was unable to open and read file_name. Verify that a valid boot disk is inserted in the
Router’s disk drive and verify that file_name is on the boot disk. Re-enter the command line.
SYSTEM: Unknown interface: iface_name
An incorrect interface name was specified on your command line. Issue the ifconfig command to
obtain a list of currently valid interfaces for your Router. Re-enter your command line.