Filter
Top Products
ATM/POS Bridge Configuration | en 15
Bosch Security Systems, Inc. Installation Manual F.01U.171.816 | 1.0 | 2010.09
5 Configuration
You must configure the ATM/POS Bridge network settings to
ensure proper communication on an existing TCP/IP network.
This section provides configuration details using the Web-based
interface.
To configure the bridge using a HyperTerminal session, refer to
Section 6 Configuration Using HyperTerminal, page 24.
For instructions to update the ATM/POS Bridge firmware, refer
to Section A Updating Bridge Firmware, page 36.
5.1 Configuring the Bridge for a Network
Connection
The ATM/POS Bridge allows two methods to configure network
settings:
– Use the Bridge Detector utility (supplied on the CD-ROM)
to set the network settings (the Device Detection
parameter must be set to Enable, refer to
Section 5.2.2 Network Setup, page 19).
or
– Use a cross-over Ethernet cable to allow an APIPA-enabled
workstation to connect to the bridge. The default network
setting for the bridge falls within the APIPA address
ranges.
5.1.1 Using the Bridge Detector Utility
1. Connect the supplied DC power adapter unit to the DC
power input connector of the bridge.
2. Connect the RJ45 connector of the bridge via a straight
Ethernet CAT5 network cable to a network switch or hub
that supports 10BaseT.
NOTICE!
Contact your local network administrator for a valid IP Address,
Subnet Mask, and a Gateway IP Address.