Filter
Top Products
ATM/POS Bridge Configuration | en 19
Bosch Security Systems, Inc. Installation Manual F.01U.171.816 | 1.0 | 2010.09
– Simulation Mode: Select the type of device to test the
connection between the bridge and the digital recorder.
Select this mode to send sample data from the bridge to
the digital recorder.
– Recording Language: Select the language that is set on the
digital recorder to ensure that characters display correctly.
– Log Level: Ensure that the Log Level setting is None. This
setting is used for diagnostic purposes only.
– Log Modules: Ensure that the Log Module setting is zero
(0). This setting is used for diagnostic purposes only.
– Restore Defaults: Resets all COM and Terminal settings to
factory defaults. This button does not reset the Network
settings.
– Reset Bridge: Reboots the bridge by cycling the power.
– Version Info: Displays the firmware release level for the
bridge.
5.2.2 Network Setup
The Network Setup enables you to provide a label for the bridge
and to configure network settings.
CAUTION!
Changing a parameter on the Network Setup page may
interrupt the operation of the ATM/POS Bridge. Contact your
network administrator before making any changes.