Filter
Top Products
ATM/POS Bridge | en 37
Bosch Security Systems, Inc. Installation Manual F.01U.171.816 | 1.0 | 2010.09
a. Unplug the power cable from the bridge.
b. Connect the supplied console cable to COM Port 3
(console) on the bridge and to a COM port on the PC.
c. Connect the supplied power adapter to the bridge
and to the main power.
The red LED light on top of the bridge flashes short
pulses to indicate that the bridge is in download
mode.
5. Click Next to select the PC COM port and to configure the
bridge communication settings.
Change the settings for the Baud rate, Data, Parity, and
Stop parameters to match the settings on the PC.
NOTICE!
if the console download cable is attached to the PC via a low-
end USB to Serial adapter, the firmware download attempt may
take several attempts before it succeeds. Bosch recommends
the SIIG USB to Serial serial adapter, a higher-end adapter.
(Manufacturer Part number: JU-CB1S12-S3)