Filter
Top Products
Leaving the Setup Mode
You can leave the program mode at any time by pressing the SETUP/EXIT
key. The “SAVE CHANGES” display will appear. There are five choices,
described below. Pressing the LEFT or RIGHT BLACK OVAL key
displays other choices and pressing the NEXT/SAVE key selects the
displayed choice.
n
PERMANENT - Permanently saves the changes. Values are stored in
the printer even when power is turned off.
n
TEMPORARY - Saves the changes until changed again or until power is
turned off.
n
CANCEL - Cancels all changes since pressing the SETUP/EXIT key
except the darkness and tear-off settings (if they were changed).
n
LOAD DEFAULTS - Loads factory defaults. The factory defaults are
shown on the following pages.
NOTE: Loading factory defaults will require printer calibration.
n
LOAD LAST SAVE - Loads values from the last permanent save.
Brady X-PLUS Series User’s Guide 45