Filter
Top Products
Cleaning the Snap Plate
Clean the snap plate to remove label adhesive or a label that has adhered to
the underside of the snap plate.
Refer to Figure 28.
1. Insert a small-blade screwdriver or similar tool into the loop on the left
side of the snap plate. Lift the snap plate.
CAUTION: Use care to not bend, twist, or otherwise deform the
loops!
2. Repeat step one on the right side of the snap plate.
3. Remove the snap plate from the printer.
4. Clean the snap plate with cleaning solvent and a soft cloth.
Refer to Figure 29.
5. To reinstall the snap plate, insert the two tabs on the bottom of the snap
plate into the two slots of the media pathway.
6. Slide the snap plate toward you.
7. Press down on the loops to lock the snap plate into place.
68 Brady X-PLUS Series User’s Guide