Filter
Top Products
Installing the Printer Driver
45
Macintosh
®
Macintosh
®
Wireless
Network
2 Click Wireless Network users.
3 Choose Wireless Setup and Driver Install,
and then click Next.
4 Choose Manual and then click Next.
5 For configuration, it is recommended that
you temporarily connect your Brother
wireless device (your printer) directly to a
free port on your access point, hub or router
using a network cable.
If you can temporarily connect with a
network cable:
Choose I’m able to temporarily connect
my device to my access point with a
network cable and then click Next. Go to
6.
If you do not have a network cable or cannot
temporarily connect the Brother wireless
device to your access point:
Choose I’m not able to connect my
device to my access point with a network
cable and then click Next. Go to 7.
6 Connect the Brother wireless device to your
access point using a network cable and click
Next. Go to 11.
7 If you choose This computer has wireless
capability., check I am using an access
point in infrastructure mode, and then click
Next. Go to 8.
If you are using a wired computer, choose This
computer uses a network cable to connect
to the wireless network., you must configure
the wireless settings from the control panel.
Click Next and follow the on-screen
instructions to complete the setup. (See
Chapter 3 in the Network User’s Guide on the
CD-ROM.) When finished, go to Installing the
printer driver on page 48 to install the printer
driver.