Filter
Top Products
A - 4
The TAD must answer within four rings (the
recommended setting is two rings). The
machine cannot hear CNG tones until the
TAD has answered the call, and with four
rings there are only 8 to 10 seconds of CNG
tones left for the fax “handshake”. Make sure
you carefully follow the instructions in this
guide for recording your outgoing message.
We do not recommend using the toll saver
feature on your external answering machine if
it exceeds five rings.
Note
If you do not receive all your faxes, reduce the
Ring Delay setting on your external TAD.
When the TAD answers a call, the LCD
shows
Telephone
.
Connections
The external TAD must be connected as
shown in the previous illustration.
1
Set your external TAD to one or two
rings. (The machine’s Ring Delay
setting does not apply.)
2
Record the outgoing message on your
external TAD.
3
Set the TAD to answer calls.
4
Set the Receive Mode to
External TAD
. (See Choosing the
Receive Mode on page 4-1.)
Recording outgoing message (OGM)
on an external TAD
Timing is important in recording this
message.
1
Record 5 seconds of silence at the
beginning of your message. (This allows
your machine time to listen for the fax
CNG tones of automatic transmissions
before they stop.)
2
Limit your speaking to 20 seconds.
Note
We recommend beginning your OGM with an
initial 5-second silence because the machine
cannot hear fax tones over a resonant or loud
voice. You may try omitting this pause, but if
your machine has trouble receiving, then you
must re-record the OGM to include it.
Improper Setup
Do not connect a TAD elsewhere on the
same phone line.
TAD
TAD