Filter
Top Products
49
SETUP SEND
Manual and Automatic Fax Redial
If you’re sending a fax manually and the line is busy, after you disconnect
the call press
Redial/Pause
to retry the number.
If you’re sending a fax automatically and the line is busy, the fax machine
will automatically redial up to three times at 5 minute intervals.
Dual Access
You can scan up to 50 documents into the fax memory, even while the fax
machine is receiving or sending another fax (from memory). You can set
temporary settings for each fax you’re scanning, except Timer and Polling.
If you try to scan in and store a 51st fax, the fax machine will send it
immediately, without storing it in memory.
If you get a MEMORY FULL message while scanning the first page of a
fax, press
Stop
to cancel scanning. If you get a MEMORY FULL message
while scanning in a subsequent page, you'll have the option to press
Start
to
transmit the pages scanned so far, or to press
Stop
to cancel the operation.
1
Make sure the document feeder is empty.
2
Place the document in the feeder.
3
Enter the fax number.
4
Press
Start
. The fax machine starts scanning the document and the
screen displays the job number (#XX) of the fax, and how much
memory is available. Then the fax machine starts dialing. You can
immediately repeat Steps 1 through 4 for the next fax.
Your fax machine normally operates in Dual Access mode. However, you
can override Dual Access by using Real Time Transmission.
Real Time Transmission
When memory is full, the fax machine cannot continue to scan documents
into memory before sending. However, you can turn on REAL TIME TX.
Then place the documents in the feeder and enter the fax number. As soon
as the phone line is free, the fax machine starts dialing and sending the fax.
1
Place the document in the feeder.
2
Press
Function
,
3
,
9
.
The screen displays
9.REALTIME TX:OFF?