Filter
Top Products
Control panel features
101
11
d Press the Go button seven times. Make sure that all the LEDs light up to indicate the print server has
been reset to its default settings.
Note
You can reset the print server back to its default factory settings using the BRAdmin applications or Web
Based Management (web browser). For more information, see Changing the print server settings
on page 12.
Enabling or disabling the wireless network (For HL-2170W) 11
If you want to switch the wireless network to enabled/disabled, please follow these steps:
a Make sure that the power cord is plugged in.
b Turn on the printer and wait until the printer is in the Ready state.
c Hold down the Go button for 10 seconds. Release the Go button when the printer prints a Network
Configuration page that indicates the current network settings.
Note
If you release the Go button in less than 10 seconds, the printer will change to the reprint mode.
d Check the text to the right side of IEEE 802.11b/g in the Node Type section. Active means that the
wireless setting is enabled and Inactive means that the wireless setting is disabled.
Note
You can switch the wireless network to enabled/disabled, using the BRAdmin applications or Web Based
Management (web browser). For more information, see Changing the print server settings on page 12.