Brother HL-2150N Network Card User Manual


 
Configuring the wireless network settings (For HL-2170W)
21
3
2. Confirm your wireless network setup method in
infrastructure mode 3
There are three methods to configure your wireless network printer; by using the Brother installer application
on the CD-ROM (recommended), using the one-push wireless setting mode and using the PIN Method of
Wi-Fi Protected Setup™. The setup process will be different depending on your network environment.
Note
If you configure the wireless network settings in Ad-hoc mode, use the Brother installer application on the
CD-ROM we have provided with the printer.
Configuration using the Brother installer application on the CD-ROM to
configure your wireless network printer 3
We recommend that you use the Brother installer application on the CD-ROM we have provided with the
printer. By using this application, you can easily connect your printer to your wireless network and install the
network software and printer driver which you need to complete the configuration of your printer for a wireless
network. You will be guided by the on-screen instructions until you are able to use your Brother wireless
network printer. You must know your wireless network settings before you proceed with this installation.
Configuration temporarily using a network cable 3
If there is an Ethernet Hub or Router in the same network as the wireless access point (A) of your printer, you
can temporarily connect the Hub or Router to the printer using an Ethernet cable (B), this is an easy way to
configure the printer. You can then remotely configure the printer from a computer on the network.
B
A