Filter
Top Products
27
Windows
®
Wireless Network
Windows
®
Macintosh
Wireless Network
n Click Next. The settings will be sent to your
printer. The settings will remain unchanged if
you click Cancel. The Network Configuration
page will be printed.
o Check the printed Network Configuration page.
Choose the status as it is shown for the
Wireless Link Status on the Network
Configuration page. Click Next.
If your status is “Link OK.”, go to q.
If your status is “Failed to Associate”, go to p.
p Click Finish. Wireless setup was unable to
associate with a wireless network. This is
probably due to incorrect security settings.
Reset the network settings to the factory
default (see page 43). Confirm the security
settings of your wireless network that you wrote
down on page 24 and try starting from e on
page 25 again.
q Disconnect the network cable between your
access point (hub or router) and the printer,
and click Next.
Install the printer driver
r When the License Agreement window
appears, click Yes if you agree to the License
Agreement.
Note
• If you want to manually enter the IP Address
settings of your printer, click
Change IP Address and enter the necessary
IP Address settings for your network.
• The wireless network setting will be
automatically changed to enabled when the
wireless settings are sent to your printer.
IMPORTANT
• DO NOT try to cancel any of the screens
during this installation.
• If your wireless settings fail, an error
message will appear during the installation
of the printer driver and the installation will
be terminated. If you encounter this failure,
reset the print server back to its default
factory setting (see page 43), and please go
back to step e on page 25 and setup the
wireless connection again.