Filter
Top Products
39
MacintoshWireless Network
Windows
®
Macintosh
Wireless Network
g Choose Automatic install (Advanced) and
click Next.
h Confirm the on-screen message and click
Next.
i Remove the label covering the USB interface
connector to press the wireless setup button.
j Press the wireless setup button located at the
back of the printer for less than 2 seconds as
shown in the illustration below. This will put the
printer in one-push wireless setting mode. This
feature will automatically detect which mode
your access point uses for one-push
configuration (SecureEasySetup™,
Wi-Fi Protected Setup or AOSS™).
k The printer starts the one-push wireless setting
mode.The printer will search for an access
point that supports SecureEasySetup™,
Wi-Fi Protected Setup or AOSS™ for 2
minutes.
l Put your access point in the
SecureEasySetup™ mode, the Wi-Fi
Protected Setup mode or the AOSS™ mode,
depending on what is supported by your
access point. Please refer to the instruction
manual that came with your access point.
m Wait until the Status LED of your printer
indicates Connected. The Status LED will
turn on for 5 minutes. (See LED indications
when using the one-push wireless setting
mode on page 53) This indication means the
printer has successfully connected to your
access point/router. You can now use your
printer with your wireless network.
If the LED indicates Connection Fail (See
LED indications when using the one-push
wireless setting mode on page 53), the printer
has not successfully connected to your access
point/router. Try starting from j again. If the
same message is indicated again, reset the
print server back to its factory default settings.
For resetting, see Reset the network settings to
the factory default on page 43.
If the LED indicates No Access Point (See
LED indications when using the one-push
wireless setting mode on page 53), the printer
has not detected a access point/router on your
network. Make sure you place the printer as
close to the network access point/router as
possible with minimal obstructions, and try
starting from j again. If the same message is
indicated again, reset the print server back to
its factory default settings and try again. For
resetting, see Reset the network settings to the
factory default on page 43.
Note
• Use a pointy object such as a ballpoint pen to
press the button.
• If you press the button for 3 seconds or more,
the printer will change to the PIN Method of the
Wi-Fi Protected Setup mode.