Filter
Top Products
36
MacintoshWireless Network
n Click Next. The settings will be sent to your
printer. The Network Configuration page will be
printed. The settings will remain unchanged if
you click Cancel.
o Check the printed Network Configuration page.
Choose the status as it is shown for the
Wireless Link Status on the Network
Configuration page. Click Next.
If your status is “Link OK.”, go to q.
If your status is “Failed to Associate”, go to p.
p Click Finish. Wireless setup failed as it was
unable to associate with a wireless network.
This is probably due to incorrect security
settings. Reset the print server back to its
factory default settings (see page 43). Confirm
the security settings that you wrote down on
page 31 your wireless network and try starting
from d on page 34 again.
q Disconnect the network cable between your
access point (hub or router) and the printer,
and click Next.
Install the printer driver
r The driver installation starts.
Follow the on-screen instructions. Then, restart
your Macintosh.
Note
• If you want to manually enter the IP Address
settings of your printer, click
Change IP Address and enter the necessary
IP Address settings for your network.
• The wireless network setting will be
automatically changed to enabled when the
wireless settings are sent to your printer.
IMPORTANT
• DO NOT try to cancel any of the screens
during this installation.
• If your wireless settings fail, an error
message will appear during the installation
of the printer driver and the installation will
be terminated. If you encounter this failure,
reset the print server back to its default
factory setting (see page 43), and please go
back to step e on page 34 and setup the
wireless connection again.
Note
Please see the User’s Guide on the CD-ROM to
install the PS driver (Brother’s BR-Script Driver).