Filter
Top Products
Troubleshooting and Routine Maintenance
95
B
Not Registered
You tried to access a Speed Dial
number that is not programmed.
Set up the Speed Dial number. (See Storing
Speed Dial numbers on page 45.)
Out of Memory The machine's memory is full. When copy operation is in progress, press
Stop/Exit and wait until the other operations in
progress finish and then try again.
The memory card or USB Flash
memory drive you are using does
not have enough free space to scan
the documents.
Delete unused files from your memory card or
USB Flash memory drive to make some free
space and then try again.
Paper Jam Paper is jammed in the machine. Remove the jammed paper by following the
steps in Printer jam or paper jam on page 97.
Make sure the paper length guide is adjusted to
the correct paper side.
Print Unable XX
The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look on the left,
middle, and right hand side under the covers for
any foreign objects inside the machine. If the
error message continues, disconnect the
machine from the power source for several
minutes then reconnect it.
Scan Unable XX
The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Open the scanner cover and look on the left,
middle, and right hand side under the covers for
any foreign objects inside the machine. If the
error message continues, disconnect the
machine from the power source for several
minutes then reconnect it.
Unusable Device
A broken device has been
connected to the USB direct
interface.
Unplug the device from the USB direct interface,
then press On/Off to turn the machine off and
then on again.
Unusable Device
Please Disconnect
USB Device.
A USB device or USB Flash
memory drive that is not supported
has been connected to the USB
direct interface.
(For more information, visit us at
http://solutions.brother.com
.)
Unplug the device from the USB direct interface.
Wrong Paper Size
Paper is not the correct size. Check that the machine’s Paper Size setting
matches the size of paper in the tray. (See Paper
Size on page 19.)
Error Message Cause Action