Filter
Top Products
24
CHAPTER TWO
Outgoing Message (OGM) of External TAD
Timing is important in recording this message. The message sets up the
ways to handle both manual and automatic fax reception.
1
Limit your speaking to 20 seconds.
2
Record 5 seconds of silence at the beginning of your message.
(This allows your MFC time to listen for the fax CNG tones of
automatic transmissions before they stop.)
3
End your 20-second message by giving your Remote Activation
Code for people sending manual faxes. For example:
“After the beep, leave a message or send a fax manually by pressing
51 and Start.”
Please note that some faxes that are sent manually cannot be received
automatically because some fax machines do not send a fax tone in
manual mode. In these cases you must inform callers that they must enter
the remote activation code to send a fax.
Connecting an External Telephone
Your MFC is equipped with a handset that you can use as a regular
phone. However, you can also connect a separate telephone to your
MFC, as shown below.
Whenever this external phone (or TAD) is in use, the screen displays
EXT. TEL IN USE, and, if the MFC’s handset is lifted, an alarm sounds.
To disconnect the call on the external phone and switch to the MFC, lift
the handset and press Tel (for MFC 730 only) or Speaker Phone (for
MFC-740 only).