Filter
Top Products
TROUBLESHOOTING 6 - 8
NC9100h_FM6.0
4
Print the Network configuration page of the NC-2200w and
check if the settings such as wireless and IP address settings
are correct for your network. The problem may be the result of
mismatched wireless setting, or mismatched or duplicate IP
address. Verify that the Wireless settings and the IP address are
correctly loaded into the NC-2200w. And make sure that no
other nodes on the network have this IP address.
5
Try pinging the NC-2200w from the host operating system
command prompt with the command:
ping ipaddress
Where the ipaddress is the NC-2200w IP address (note that
in some instances it can take up to a few minutes for the NC-
2200w to load its IP address after setting the IP address or
powered on).
6
If you have tried 4 or 5 above and it does not work, then reset
the NC-2200w back to the default setting and try from the initial
setup again. For the information how to reset to the factory
default setting see Test Button on page 1-4.
7
Check if a personal firewall such as ICF for Windows
®
XP is
running on your computer. If it is running, temporarily turn it off
and try again.