Filter
Top Products
6 - 9 TROUBLESHOOTING
NC9100h_FM6.0
Printing Problem
Print Job is not printed
Make sure the status and configuration of the NC-2200w and the
Printer/MFC/DCP, check following:
1
Check if the Brother NC-2200w power is turned on
2
Check if the Brother NC-2200w is securely connected to the
Brother Printer/MFC/DCP and the Printer/MFC/DCP is powered
on.
3
Make sure the printer/MFC/DCP is on-line and ready to print.
4
Move your PC closer to the Brother Printer/MFC/DCP with the
NC-220w installed and try gain
5
Print the Network configuration page of the NC-2200w and
check if the settings such as wireless and IP address settings
are correct for your network. The problem may be the result of
mismatched wireless setting, or mismatched or duplicate IP
address. Verify that the Wireless settings and the IP address are
correctly loaded into the NC-2200w. And make sure that no
other nodes on the network have this IP address.
6
Try pinging the NC-2200w from the host operating system
command prompt with the command:
ping ipaddress
Where the ipaddress is the NC-2200w IP address (note that
in some instances it can take up to a few minutes for the NC-
2200w to load its IP address after setting the IP address or
powered on).