Filter
Top Products
12
Installation (Please read before Installing!)
Please Read Before Installation
• Before beginning the installation, check that the computer meets the system requirements.
• In order to install the software, you must log on to the computer using an account with administra-
tor privileges. For details on logging on to the computer using an account with administrator privi-
leges, refer to the Windows manual.
• The installation procedure is described for Windows
®
XP. The procedure and dialog boxes for other
operating systems may be slightly different.
• If the installation is canceled before it is completed or if the procedure is not performed as de-
scribed, the software will not be installed correctly.
• Do not remove the CD-ROM from the CD-ROM drive of the computer while the installation is be-
ing performed. Remove the CD-ROM after the installation is completed.
• Before turning on the computer, be sure to disconnect the USB card writer module.
• In order to upgrade the USB card writer module, you must be able to connect to the Internet. If you
cannot connect to the Internet, contact your authorized dealer or Brother Customer Service.
• When upgrading from version 5.02 or later, skip STEP 2 and continue with STEP 3.
•
If the USB card writer module is not upgraded, it can only be used the limited number of times that the soft-
ware can be used. In order to upgrade the USB card writer module, be sure to perform STEP 3 on page 19.
Installation Procedure
The installation procedure is different depending on whether the full version or an upgrade of the
software is being installed. Be sure to perform the installation procedures listed below.
■ Installing version 7.0 (full version)
[STEP 1] Installing the software ................................................................................☞ page 13
[STEP 2] Installing the driver for the card writer module ......................................... ☞ page 16
■ Upgrading from version 5.0 or 5.01
[STEP 1] Installing the software ................................................................................☞ page 13
[STEP 2] Installing the driver for the card writer module ......................................... ☞ page 16
[STEP 3] Upgrading the USB card writer module .....................................................
☞ page 19
■ Upgrading from version 5.02 or later
[STEP 1] Installing the software ................................................................................☞ page 13
Memo:
• When upgrading from version 5.02 or later, STEP 2 is not performed.
[STEP 3] Upgrading the USB card writer module ..................................................... ☞ page 19
PED7_QSG.indb Sec1:12PED7_QSG.indb Sec1:12 02.06.2006 20:07:0002.06.2006 20:07:00