Filter
Top Products
16
Step 2: Installing the Driver for the Card Writer Module
This section describes how to install the driver for the card writer
module.
a Plug the USB connector into the USB port on
the computer.
Make sure that the connector is fully inserted.
b Install the driver for the card writer module.
■ For Windows
®
XP with Service Pack 2 already
installed and connected to the Internet:
Note:
• Depending on the computer, this
dialog box may not appear. If it
does not appear, skip this step and
continue with the procedure.
Note:
• If you upgrading from version 5.02
or later, skip this section and con-
tinue with the procedure described
in “[STEP 3] Upgrading the USB
card writer module” on page 19.
Memo:
• To check whether or not Service
Pack 2 is installed, click Start, and
then click on Control Panel, then,
double-click on System to open the
Properties page.
Select Yes, this time only,
and then click Next.
Select Install the software auto-
matically (Recommended), and
then click Next.
PED7_QSG.indb Sec1:16PED7_QSG.indb Sec1:16 02.06.2006 20:07:0302.06.2006 20:07:03