Filter
Top Products
46
If you have a problem, check the following solutions. If the solutions suggested do not correct the
problem, contact your authorized dealer or Brother Customer Service.
Problem Estimated Cause Solution Page
The software is not installed
correctly.
An operation not
described in the instal-
lation procedure was
performed. (For exam-
ple, Cancel was clicked
or the CD-ROM was
removed before the pro-
cedure was completed.)
Follow the instructions and cor-
rectly perform the procedure.
12
The installer does not
automatically start up.
Refer to memo: “If the installer
does not automatically start
up”.
14
The message “No card writer
module is connected. Please
connect card writer module.”
appeared.
The driver for the USB
card writer module is not
installed correctly.
When the USB connector is
correctly plugged into the USB
port, the installer for the driver
of the USB card writer module
starts up.
For details, refer to “Installing
the driver for the card writer
module” on page 16.
If the opera-
tion described
at the left does
not correct
the problem,
go to the Web
site mentioned
under “Techni-
cal Support”.
(Refer to page
22.)
The message “Old version
is not installed correctly.
Please install old version
before installing this updated
program.” appears when the
upgrade is being installed,
even though an older version
(version 5 or 6) is installed.
The installation informa-
tion for the old version
on the computer is not
working properly.
Uninstall the older version from
the computer, install the older
version again, and then perform
the upgrade.
If the opera-
tion described
at the left does
not correct
the problem,
go to the Web
site mentioned
under “Techni-
cal Support”.
(Refer to page
22.)
When upgrading from ver-
sion 5.0 or 5.01, the installa-
tion was completed correctly,
but the message “No card
writer module is connected.
Please connect card writer
module.” appeared, and the
application does not start up.
The upgrade from ver-
sion 5.0 or 5.01 was
performed with the USB
card writer module con-
nected.
When the USB card writer
module is unplugged, then rep-
lugged into the PC, the installer
for the driver of the USB card
writer module starts up.
16
Troubleshooting
PED7_QSG_06.indd Sec1:46PED7_QSG_06.indd Sec1:46 08.06.2006 10:43:5408.06.2006 10:43:54