Brother PT-3600 Printer User Manual


 
82
Ch. 4 Machine Adjustments
Machine Adjustments
To change the HALF CUTTER setting:
This function allows you to adjust how deep a
half cut is cut with laminated tape, for example,
if the tape is cut too much or not enough. Nor-
mally, it is only necessary to change the setting
by one. If the half cut is still either too deep or
not deep enough, change the setting by one
again.
1 Hold down d and press A.
2 Press j or k until
HALF CUTTER
is dis-
played.
3 Press m or g until the desired setting is
displayed.
4 Press n to apply the setting.
To change the USB ID SELECTION setting:
This function allows you to specify a unique
identification number for each P-touch con-
nected to a computer in order to print through
the USB connection. Normally, for easy setup of
multiple P-touch machines connected to a com-
puter, all PT-9600/3600s will be set to
000000001, indicating that the data will be
printed on all connected P-touch machines at
the same time.
1 Hold down d and press A.
2 Press j or k until USB ID SELECTION is
displayed.
3 Press m or g until the desired setting is
displayed.
4 Press n to apply the setting.
NOTE
If the tape is still not cut correctly even after this set-
ting has been continuously adjusted, the cutter may
be dull. Contact your service representative.
NOTE
This step may be skipped if settings for several
Setup functions are being applied at the same time.
NOTE
To cut less deep, select a lower value. To cut
deeper, select a higher value.
Adjust the setting in small steps.
To return the function to its default setting (0),
press the space bar.
NOTE
To apply several Setup settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
Length Margin Font Width Size
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
K
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
R
R
R
R
R
R
G
H
I
J
06/07
HALF CUTTER
00±3
AUTO 1.00 HELSINKI A AUTO
L
M
NO
NOTE
This step may be skipped if settings for several
Setup functions are being applied at the same time.
NOTE
To return the function to its default setting
(000000001), press the space bar.
NOTE
To apply several Setup settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
Length Margin Font Width Size
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
K
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
R
R
R
R
R
R
G
H
I
J
07/07
USB ID SELECTION
000000001
AUTO 1.00 HELSINKI A AUTO
L
M
NO