Filter
Top Products
Configuring your machine for a wireless network (Not available for MFC-5490CN and MFC-5890CN)
34
3
i Press .
(For Windows
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install MFL-Pro Suite or
Initial Installation / Install MFL-Pro Suite from the CD-ROM menu.
(For Macintosh
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Start Here OSX from the
CD-ROM menu.
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows Connection status Action
Setting WLAN
Searching or accessing the access point,
and downloading settings from the access
point.
—
Connecting SES
Connecting WPS
Connecting AOSS
Connecting to the access point. —
Connected Connection succeeded. —
Connection Failed
Connection failed.
(If this is shown after the LCD shows
Connecting SES, Connecting WPS or
Connecting AOSS.)
1 Try starting from e again.
2 If the same message continues,
reset the machine back to the
factory settings and try again.
A session overlap was detected. Check that only one router or access
point has SecureEasySetup™, the
Wi-Fi Protected Setup™ mode or
AOSS™ mode enabled and try starting
from e again.
Incorrect Mode A session overlap was detected.