Filter
Top Products
Wireless Configuration for Macintosh
®
using the Brother installer application (Not available for MFC-5490CN and MFC-5890CN)
74
5
o If your network is configured for Authentication and Encryption, the following screen will appear. When
configuring your Brother wireless machine, you must ensure that it is configured to match the
Authentication and Encryption settings of your existing wireless network. Choose the
Authentication Method and Encryption Mode from the pull-down list in each setting box. Then enter
the Network Key and Confirm Network Key, and then click Next.
Note
• If you want to setup or configure additional WEP key indexes other than WEP key1, click Advanced.
• If you do not know the Authentication or Encryption settings for your network, contact your network
administrator.
• If your machine is not detected, go to step a on page 69 and setup the wireless connection again.
• If you are using WEP and the LCD displayed ‘Connected’ but your machine is not found, make sure you
entered the WEP key correctly. The WEP key is case sensitive.
p Click Next. The settings will be sent to your machine. The settings will remain unchanged if you click
Cancel.
Note
If you want to manually enter the IP address settings of your machine, click Change IP Address and enter
the necessary IP address settings for your network.